Did you check the muffler bearings? Maybe slap some grease on them shits.

Sounds like something coming from valve trian

sounds like a turbo going bad when you plug in the injector it makes more pressure and leaks.

Belt tensioner lol talked to my bro, he's smart with things... Belt tensioner

It’s probably because you took the pink valve cover off bro!

Could be spark nock

Hey doods! I'm curious if you guys have seen Doug's tech tip video. He discusses how front tire pressure can promote wheelies. After he mentioned it, I thought well duh, no chit man! I thought that should be obvious, yet front tire pressure never occurred to me either. Like he said, this isn't something that is talked about much.

Your Exhaust gasket is done 🥴

2jzgte. Barra. Time to play with the motors thatll actually be able to give you longer trouble free periods.

Pull that Fuel injector. And test it

That is definitely an exhaust leak lmao

Waste gate or blow off or exhaust or spark plug lose. One those Broken or leaking or something lose plug or broken. Boost solenoid. Or a strap hanging and chattering spark jump in coil over plug. Maybe one these will spark something in mind

Piston slap?

I love that engine 💪🏻💪🏻💪🏻

You guys are awesome love all your content

Exhaust leak🤙

Damn, ordered a shirt almost as soon as this video was posted and just got the shirt. Was really hoping for a valve. I got unlucky.

I feel it's not the head. Once there's a load on cylnder one it makes the sound. I want to say it's the rist pin once there's a load on the piston the rist pin is squeak / ticks basicly rate one ignition happens making it sound like it's coming from higher up in the motor

Sounds kinda like it's detonation

Start pulling the pan I'll bet there's a loose part down low

Could be a wrist pin or something? It would sound close to the top end

Sounds like bottom end to me. Check your rods.

Maybe you left something in the head when you had it apart lol its rattling around only way you'll figure it out is if you take it apart as annoying as that is. Good luck dude can't wait to see you make another clean 8 second pass with this thing

Wyatts a fucking trip man 😂

I'm thinking its the injector. It has to be the injector, if was anything else it would still make the noise. The injector

Rod knock? My subie did the exact same thing with the coil unplugged it went away also went away at high rpm like yours did eventually motor took a crap

Drop the pan and make sure you can’t move the piston skirt. I had a problem in a diesel pretty similar lost no power but pulled the oil pan and the piston got hot and it scuffed the wall

crack in the exhaust or gasket maybe, sounds like an old old car with holes in the exhaust, on camera at least :p

or piston slap one time i hope not

iv heard rist pins do that before

Another 16 valves available

That’s a clean engine bay

what the fuck? thats an electrical short

Sounds like a broken wrist pin to me

yo kyle check if you have an enjector leaking bc jimmy oaks had the same problem and it was an injector leak on the seal

Mister Two is so cool 😎

Yes sir, race car life lol 💯👍👍👍

Think it's in the AC system

Why is there a pouch on the back of the mr2? If it's parachute trust me it's not needed

It’s bend rod or wrist pin bad

what happened to charlie

Part out? lol

Down there in Florida you should be running a thicker oil and you might want to check into getting a beefier set of lifters instead of running stock lifters and yes that is a weird noise especially since everything is fine hardware wise and it makes the noise when the injector is plugged in but stops with the injector unplugged but definitely sounds like lifter chatter

I'm guessing broken lifter bucket.

I had a cracked piston skirt that sounded just like that. It cracked in a W shape and stayed together

Compression check

Check the small end

Little end bearing, that chirping is the piston moving

You can always tell when it's a piston hollow round aluminum noise

That would be piston slapper wrist pin slap

8:35 that's just the vtec kicking in bro dont worry

Just turn the radio up

Conrod bearing no.1?

My bet is the impact spun a bearing of some sort

So that's what aluminum rods knocking sounds like. . .

sounds like a fuel knock

Wheres the boosted bois pfi speed car giveaway!!??

Just swap back to 3sgte is better than k24

bad injector.....?

Sounds like exhaust gas leaking at a header.

Valve stem Daddy

That’s where that missing 10mm went

I vote wrist pin Kyle

Wrist pin. Or throw out bearing

Check the manifold!

Sounds like maybe an exhaust header gasket letting air blow by making a slight whistle sound.

District 9 alien in your engine?

https://youtu.be/knnePx3RXLE

It's honestly a sin to what a boostedboiz video and not give it a like fuck

Yes please make it hapen go an killl it work on the van we wat the van to race on hoonigan please

Exhaust leak!

Exhaust leak ? Or worse piston related slap or wrist pin. I hope you find it without too much R&R

Might be the header gasket fluttering just a guess

Piston slap or wrist pin

"you guys probably wouldn't understand" oh no we do..... We do. Especially when you want to make an event. It's painful to just be like shit isn't right... Lol

Probs wrong, but could a valve be a little shorter than the rest?, so a small amount of exhaust gas exists when that particular cylinder fires?

Its your flux capacitor....... Come on 1 mill subs.

Also could try checking for weak springs. Had that before (floating valve)

Sounds like a valve nicking the piston.. overextension. Mic out the Lobes & mic out valve depth of valve head.
Easy fix
Otherwise check cylinder sleeve for slap slack or piston pin slack.
Hope you find the issue if not one of those.
👍Good luck

Content went to shit when you left Colorado. I guess everyone else made the channel.

Piston wrist pin

I’m tempted to pay the 25 usd shipping to Australia for a sticker in hopes I’ll get a valve

Cracked piston skirt causing piston slap? Or small end rod bearing

maybe pre detonation if the injectors half clogged try the other injector

It almost sounds like the valves are hitting the piston idk though ive never heard anything like that before on an engine or maybe the rockers are loose, you guys will figure it out I have faith in ya.

Check the wastegates ..that’s definitely an exhaust leak

Do u have a mock up of that mid plate. Or dimensions

My guess is a cracked manifold runner on no1 or a leaking gasket

"Something probably had to settle in", nice way of saying let it self clearance 😆

Bustedboiz

exhaust gasket?

YeAh buy some merch for a chance to win some busted ass parts. Unsubscribed.

I feel like thats an exhaust manifold gasket leak on Cyl , seems a lot of people also feel that way. hopefully it's that simple.

Loose or cracked spark plug causes ticking sound in engine. Spark plug seal off the cylinder. Bad plug may sometimes strip the cylinder head threads. If that happens, you'll need to repair or replace the damaged cylinder head. If not that, you'll need a new piston, and rings.

Lost motion assembly

Brent where's your ear ...... .😂🤘😁❤

could it be the valve cover

You probably dropped a ten mil inside the motor

Sounds just like an exhaust leak to me.

On today’s episode of how fucked up is fucked up ...
BoostedBoiz: